Homemade wifi booster signal

So directing the antenna to concentrate the signal helps boost your wifi range! Using a pot, a can or a metal bowl you can concentrate your signal. You can also use these with wireless access points.

If your house is large enough that you need multiple devices, using a pan can help capture the signal as it repeats between devices too. Get a Wireless Range Extender. Some of these are expensive — BUT there are also software programs that can use your computer as a hotspot to help extend your signal. The biggest thing you need to watch out for when choosing one, though, is to make sure it runs on the same signal type as your router.

Optimize the Frequency Band: Depending on the frequency band your router is operating off of, you may get interference from other sources that are operating on the same frequency. Dual-band routers should be set to the 5GHz since most routers are operating off of a single band and fewer sources will be set to this. Fewer people operating on a band means less interference and greater wifi range.

Easy to follow step-by-step plan, and pictures are included, including making your own cantenna, and a parabolic reflector from foil. A DIY WiFi booster can be as simple as a piece of aluminum foil and a bowl, through to making your own cantenna from a can. Even a novice can boost a wireless signal using these four methods to make your own WiFi signal booster. However, if you want better results buying a wifi extender will be better. Using a DIY WiFi booster is an excellent way to improve your signal for little to no investment, other than a few minutes of your time.

Several things can impact the WiFi signal, from the thickness of walls to the usage of microwaves near the router. You might be better off trying out a different material with the Deep Dish, as well as a smaller template. These results are not particularly scientific and are just meant to give you an idea of what to expect. Your mileage may vary. Both of these designs were meant to be used with wifi routers that have external antennae sticking out, but many modern routers—the modem-router combos you get from your ISP in particular—often use an internal antenna.

For those of you with multiple antennae, we recommend building multiple extenders. For a single floor, your wifi antennae should always be sticking straight up and, if you have multiple antannae, parallel. You may need to lie them flat, parallel with the floor, to get the signal to go up and down. Always keep your antennae parallel if you have more than one.

The key is that the reflectors need to made of something… well, reflective. And the struts should be made of something very not reflective.

The designer notes:. These extenders get the job done, but you might also be able to boost the signal from your wifi router by adjusting settings in the firmware. Depending on your firmware, you can amp up the throughput and achieve greater range and signal strength. Just be careful, as this will also make your router run hotter and could damage or shorten its lifespan. You can download them for free and print them out. If necessary, resize the pictures before printing them.

Glue the printed paper on the construction paper. This will give the antenna some stability. Cut along the patterns. Make six incisions and stick the aluminum foil on it. Enfold the rectangular piece in glue and foil. Take the other part and bend it at the halfway point. Insert the tabs in the holes. Staple them. Set this on your wifi antenna. If the bowl has a handle, take it off. Run the antenna cable in the resulting hole. Use a drill to enlarge the hole if needed.

Get the wifi antenna. Place it in the center of the bowl. Placing it in the middle forces the wave flow in one direction. Put this homemade wireless signal booster in the desired location.

If necessary tape it there. Now try the device to see how much the signal improves.