Installing mx graphics

Place your dirt bike graphics over the plastic e. Using adhesive paper tape, tape down the decal to the plastic. This will hold your decal in place. Use as much tape as you need. Peel the backing paper away from the background till the middle, cut it off. Re-check your alignment on the part to be covered. Touch one side of the graphic with your finger to place it. Working in small sections, use your thumb or squeegee to apply pressure to the graphics being careful not to get any wrinkles or bubbles.

You have to work from the center out. If you get bubbles, carefully peel the section up and try again. Use the safety pin to pop any small air bubbles. Then smooth out the bubble section moving towards the edges of the graphics. Make note of holes and curves and align accordingly. Peel the backing paper away from the background. Re-check your alignment on the part to be covered. Touch one side of the graphic with your finger to place it. With one hand maintain the alignment of the graphic, with your other hand touch a few spots along the center to place it.

Working in small sections, use your finger tips to apply pressure to the graphic being careful not to get any wrinkles or bubbles.

You want to work from the center out. Click Remove, the driver will uninstall. Click that then follow the instructions. On the new window, check the devices you want the display driver to be uninstalled for.

If there is a "Primary" and "Secondary", check both of them. Click OK. Follow any prompts, the driver will then uninstall. OR The installer for the new drivers has an uninstallation feature in it. Just double click the drivers you downloaded and use the Uninstall feature. This part is optional, but I would recommend it since it ensures all remnants of the old drivers are deleted.

Once it is download, install it. Reboot your system into safemode. To boot into safe mode, restart your computer, right when it turns on, tap the F8 key once every second or so. Your computer will now boot into safe mode. Once at your desktop, start up Driver Sweeper. Click Clean, the program will delete all remaining files from the drivers.

Reboot into safe mode again. Installing the New Drivers Almost there, all that there is left is to install the new drivers. Once at your desktop in safe mode, find where you downloaded the installer for the new graphic drivers. All you have to do is start the installer and follow the prompts.